VOIP-500
Series Phone
Configuration and Operation Manual
Page
56
of
90
Copyright 2012 Talk-A-Phone Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
5. Operations
The phone takes approximately one minute to boot.
While the first and second LED’s are flash, the unit is still
booting (Refer to Figure 1 Front View). After all LED
’s
clear, wait for an additional twenty seconds before
initiating a call.
The phone needs to be programmed in accordance with the instructions provided in Chapter 4 (Refer to 4
Using the Web GUI).
5.1. Calling Emergency/Information Numbers
In case of an emergency, the phone can dial a list of numbers (Refer to 4.5.1 Number Lists) in round robin
fashion. Depending on the device mode and programming, a call is automatically initiated when:
Push button is pressed
Auxiliary Input is activated
Handset goes off-hook (0BH device mode only)
If the first number does not answer within a specified time (Refer to 4.5.4 Call Parameters) the phone dials
the next number from the number list. It continues to dial in round robin fashion until the call is answered, or
the call conversation timer expires (Refer to 4.5.4 Call Parameters: Call Conversation Timer).
5.2. Answering the Emergency/Information Call
One of the following scenarios occurs upon answering the emergency call on the remote side:
The VOIP-500 Series Phone may transmit its location by playing a recorded message (Refer to 4.7.2
Played to Remote Side). If no such feature is enabled or when the voice message completes playing,
the caller may talk and listen hands-free
19
without using any controls.
The VOIP-500 Series Phone may transmit a voice message and request that the remote side user to
press a specific key on the keypad of the remote side phone (Refer to 4.5.4 Call Parameters: answer
a call) to answer this call. Providing the incorrect key sequence within three attempts will terminate
the call. Once the call is terminated, a new call is made to the next number on the list. On providing
the correct key sequence, the VOIP-500 Series Phone may transmit its location by playing a recorded
message (Refer to 4.7.2 Played to Remote Side). If no such feature is enabled, the caller may talk
and listen hands-free
20
without using any controls.
5.3. Terminating Calls
Round robin calls can be terminated only from the remote side by going on-hook or by pressing a specific call
termination key on the remote keypad (Refer to 4.5.4 Call Parameters). Calls placed from the keypad can be
terminated locally using button(s) programmed as a hook switch (Refer to 4.6.1 Buttons) or from the remote
side by going on-hook/pressing a specific call termination key.
For phones with just a handset and no speaker, calls (both round robin and keypad calls) can be terminated
locally by going on-hook.
19
Depends on device mode
20
Depends on device mode
