VOIP-500
Series Phone
Configuration and Operation Manual
Page
33
of
90
Copyright 2012 Talk-A-Phone Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
Figure 17 Auxiliary Outputs
To configure the auxiliary outputs:
1.
Use the drop-down menu to select the Auxiliary Output. If desired, assign a label to the Auxiliary Output.
2.
Configure various events that should activate an Auxiliary Output.
i.
Button Events
The button events are available only when the Buttons are programmed for Autodial mode (Refer to
4.6.1 Buttons: for
Autodial
).
Configure Auxiliary Output activation on Button #1 and/or Button #2 when a call is
INITIATED
,
ANSWERED
, or
TERMINATED
.
Use the drop-down menu to select the duration for which the Auxiliary Output should remain
active (i.e.
ENTIRE CALL
(deactivates after the termination of the call),
CONTINUOUS
(activated indefinitely until deactivated by a deactivation event), or
CUSTOM
(activated for the
specified duration in seconds).
ii.
Auxiliary Input Events
Configure the Auxiliary Output activation on activation/deactivation of Auxiliary Input #1,
Auxiliary Input #2, and Auxiliary Input #3.
Configure the duration separately for the idle state and the active call state. Use the drop-down
menu to select the duration for which the Auxiliary Output should remain active (i.e.
ENTIRE
CALL
(deactivates after the termination of the call),
CONTINUOUS
(activated indefinitely until
deactivated by a deactivation event), or
CUSTOM
(activated for the specified duration in
seconds).
3 (i)
3 (ii)
3 (iii)
3 (iv)
3 (v)
3 (vi)
