VOIP-500
Series Phone
Configuration and Operation Manual
Page
40
of
90
Copyright 2012 Talk-A-Phone Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
iii. Select and enter the Key Code sequence
13
entered by the remote side to play the voice message to
the User when the corresponding key sequence is entered by the remote side during an active call.
iv. Select and enter the Key Code sequence
14
entered locally on the phone keypad to play the voice
message to the User when the corresponding key sequence is entered by the local User during
idle/active call state.
v. Select the Button #3 and Button #4 events to play the voice message when the Button #3 or Button
#4 is pressed by the local User on the phone. The Button #3 and Button #4 events are available only
for the buttons programmed as “Play Voice Message” (Refer to 4.6.1 Buttons).
3.
Select Looping
–
Yes/No to play the voice message in a loop until the “stop message” event occur
s.
4.
The selected voice message stops playing on the selection of one of the following events:
i.
Select
On inbound calls when answered
to stop playing the current voice message when the
phone answers an inbound call.
ii. Select Auxiliary Input Activation/Deactivation events to stop playing the current voice message on
activation/deactivation of an Auxiliary Input Device.
iii. Select and enter the Key Code sequence entered by the remote side to stop playing the current
voice message when the corresponding key sequence is entered by the remote side during an
active call.
iv. Select and enter the Key Code sequence entered locally on the phone keypad to stop playing the
current voice message when the corresponding key sequence is entered by the local User during
idle/active call state.
v. Select the Button #3 and Button #4 events to stop playing the current voice message when the
Button #3 or Button #4 is pressed by local User on the phone. The Button #3 and Button #4 events
are available only for buttons programmed as “Play Voice
Message” (Refer to 4.6.1 Buttons).
5.
Click
Apply
to save settings.
Note: You cannot use the same event to activate and deactivate the same voice message.
13
If DTMF Authentication is enabled (see section 4.8) the Guard Access Code will need to be entered before any other code may be used.
14
If DTMF Authentication is enabled (see section 4.8) the Guard Access Code will need to be entered before any other code may be used.
