VOIP-500
Series Phone
Configuration and Operation Manual
Page
37
of
90
Copyright 2012 Talk-A-Phone Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
Figure 19 Digital Outputs - Events
To configure the auxiliary outputs:
1.
Configure various events that should activate a Digital Output.
i.
Button Events
The button events are available only when the Buttons are programmed for Autodial mode (Refer to
4.6.1 Buttons: for
Autodial
).
Configure Primary Digital Output activation on Button #1 and/or Button #2 when a call is
INITIATED
,
ANSWERED
, or
TERMINATED
.
ii.
Auxiliary Input Events
Configure the Primary Digital Output activation on activation/deactivation of Auxiliary Input #1,
Auxiliary Input #2, and Auxiliary Input #3.
iii.
Remote Side Key Codes
Configure the Key Code sequence to be used by the remote side to activate the corresponding
Digital Output.
iv.
Local Key Codes
Configure the Key Code sequence to be used by the Local User to activate the corresponding
Digital Output
11
.
2.
Configure various events on which the Secondary Digital Output(s) needs to be deactivated. Secondary
Digital Outputs are commonly used to send a deactivation script.
i.
Button Events
The button events are available only when the Buttons are programmed for Autodial mode (Refer to
4.6.1 Buttons: for
Autodial
).
Configure the Secondary Digital Output activation on Button #1 and/or Button #2 when a call is
INITIATED
,
ANSWERED
, or
TERMINATED
, after the defined duration of time has elapsed.
11
If DTMF Authentication is enabled (see section 4.8) the Guard Access Code will need to be entered before any other code may be used.
2
