TAJIMA TCMX 601, User Manual

Page: 54 / 130

Functions that are frequently used
5-13
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Outline of automatic offset ........................................................
1.
When you start the machine, the embroidery frame will move
to the start position of design (C) through the middle position
(B), and embroidery will start.
2.
The machine will stop at the end position of design (D) to
perform thread trimming, and the embroidery frame will
move to the offset start position (A) through the middle
position (B).
3.
When you change fabric and start the machine, the
embroidery frame will move to the start position of design
(C) through the middle position (B), and embroidery will
start.
It is possible to perform this example when the following
settings are set to “to perform”.
“Automatic start”
“ATH”
If there is no middle position (B), the frame will not go
through.
B: Middle position (OF1)
C: Start position of design
D: End position of design
A
B
D
C
1
1
3
2
2
A: Offset start position (OF2)
3
OF2
OF1
* The numbers show
the contents of movements
explained as shown left.
C
A
B
To C
D
A
B
To A
C
A
B
To C
JZ07