TAJIMA TCMX 601, User Manual

Page: 122 / 130

Supplemental documentation
15-3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
DESIGN DATA
Data to embroider design It consists of design and data such as embroidery mode
DESIGN INTERVAL
Amount of movement (mm) when one design moves to the next design in repeat embroidery of the same design
DESIGN INTERVAL FUNCTION
Moving method when moving one design to the next design in embroidering the same design repeatedly Moving method includes
by stitch and by frame stepping (frame stepping only for TMLH series)
DIP SWITCH
A small slide switch to change conditions of machine movements
DST
Abbreviation of Design System of Tajima. Tajima format. Refer to TBF.
DSW
Abbreviation of Dual in Package Switch Refer to DIP switch
E
EMBROIDERY FRAME
A general term of frames that hold material to be embroidered such as cloth, leather, etc.
END CODE
There are the code that indicates the end point of embroidery (end code 2) and the code that indicates the pause in designs to be
repeated (end code 1)
EXCITATION
To generate magnetic power by sending electric current into coil such as electric magnet, etc.
F
FDD
Abbreviation of Floppy Disk Drive Refer to Floppy Disk Drive
FIXED PITCH MOVEMENT
To move the frame to right or left direction (X-axis direction) by preset head pitch (head interval)
FIXED POSITION
It is the regular stop position, and is indicated by angle of the main shaft of the machine.
FLOPPY DISK
An external memory device of which round shaped polyester surface is pasted with magnetic powder. It is used for storing design
data, etc.
FLOPPY DISK DRIVE
A device to write or read data or program of floppy disk
FRAME BACK
To move the embroidery frame only to the returning direction of stitches with the needle bar(s) stopped
FRAME FORWARD
To move the embroidery frame only to the advancing direction of stitches with the needle bar(s) stopped
FRAME LIMIT SWITCH
Switch to limit the embroidery range
FRAME LIMIT
The embroidery space limited by the frame limit switches
FRAME
Refer to embroidery frame
FRAME STEPPING
To move the embroidery frame only with the main shaft of the machine kept stopped during embroidery
FUNCTION CODE
A control code to specify function or action of the machine
H
HALF CUT
To cut only the upper material of piled materials (usually two pieces) by laser irradiation
I
INCHING
Very slow rotation of the main shaft when the machine starts or before it stops
J
JUMP
Not to activate needle bar by cutting off the driving force from needle bar driving mechanism. It is possible to generate longer
stitch than the maximum length of one stitch (12.7 mm) by making the machine perform jumping. In addition, when the machine
stops, it is always in a state of jumping.
JZ07