TAJIMA NEO TEJTII-C, User Manual

Page: 87 / 118

9-4
9. Manual operation
Offset (setting for position)
Offset (setting for position)
Set offset position.
1.
Select offset
When changing frame type, the offset
position will return to (0, 0).
2.
Setting for offset position
Set an offset position using frame
travel key. Moving position of the
frame will be displayed with
coordinates.
3.
Set
Pressing "SET" will cause the set
position to be registered to the
machine and to be used for all design
data.
4.
Completion
When setting offset of frame setting to
auto, the frame will move to the offset
position when the machine stops
temporarily or after completion of
embroidery. At this moment, the
screen shown left will be displayed.
The screen shows that the machine
stops at the offset position.
5.
............................................................... Return to the original
position
Pressing the offset key will cause the
frame to return to the position before
travel.
CAUTION
When performing this operation, do not put your hands
under the needle or on the machine table. If your hands are
under the needle or on the machine table, you may be
injured by the needle or the moving frame.
JZ05
* * * * E M B S T A R T * * * *
T A J I M A 1 2 . D S T 1
0 / 1 0 2 7
01/15: 23456789AB<D>
1
Offset
* * * * E M B S T A R T * * * *
O F F S E T
D x + 0 . 0 ( + 0 . 0 )
D y + 0 . 0 ( + 0 . 0 )
Frame
Position
* * * * E M B S T A R T * * * *
O F F S E T
D x + 2 7 . 1 ( + 0 . 0 )
D y - 5 6 . 4 ( + 0 . 0 )
Set
* * * * E M B S T A R T * * * *
O F F S E T
D x + 2 7 . 1 ( + 2 7 . 1 )
D y - 5 6 . 4 ( - 5 6 . 4 )
* * * * E M B S T A R T * * * *
O F F S E T
D x + 2 7 . 1 ( + 2 7 . 1 )
D y - 5 6 . 4 ( - 5 6 . 4 )
* * * * E M B S T A R T * * * *
T A J I M A 1 2 . D S T 1
0 / 1 0 2 7
01/15: 23456789AB<D>
1
Offset