TAJIMA NEO TEJTII-C, User Manual

Page: 34 / 118

3. Basic operation
Test mode
3-13
Test mode
LCD screen displayed at test mode is explained here.
Detach the cover that is located at the back of the operation panel while turning OFF the
power, set No.1 of DIP switch 1 (DSW1) to “ON” and then turn ON the power.
z
Test mode
A: Tie stitching (So: “To perform” at the start/S-: “Not to perform” at
the start
Eo: “To perform” at end of embroidery/E-: "Not to perform" at end
of embroidery)
B: Satin stitch (-: Without correction, 1 to 5: in increments of 0.1 mm)
C: Boring (OFF/1/2)
Not available to use
in 1-needle machine.
D: Cording (ON/OFF)
Not available to use in 1-needle machine.
E: Sequin

Sequin Setting
a: Up/down of sequin device (U: up/D: down)
When the needle bar with sequin device is not selected, the machine will not
work.
b: Feed amount of sequin (FF/4.0 to 9.9 mm)
c: Manual sequin chip feed
When the needle bar with sequin device is not selected, the machine will not
work.
Not available to use in 1-needle machine.
(1) Main
(2) XY
(3) Panel
(4) Embroidery information
Ma
ch
ine sett
ing
** MACHINE SETTING *
A TIE SET So Eo
B.SATIN ADJ OFF
C.BORING OFF
.
A
C
B
Set
** MACHINE SETTING *
D CORDING OFF
E.SEQUIN SET [SET]
.
D
E
****** SEQUIN ******
UP/DOWN U < > D
SEQUIN L 6.7mm
SEQUIN R OFF
a
b
****** SEQUIN ******
SEQUIN L 6.7mm
SEQUIN R OFF
FEED F >
c
JZ05
DIP switch
1 2
3 4 5 6 7 8
ON
DSW1
** TEJT2-C series **
TEST MODE
<1>
Set
Te
st
m
od
e
***** TEST MODE ****
(1) MAIN Ver T.3
(2) XY Ver T.3
(3) PANEL Ver T.1
***** TEST MODE ****
(2) XY Ver T.3
(3) PANEL Ver T.1
(4) EMB INFORMATION