TAJIMA NEO TEJTII-C, User Manual

Page: 81 / 118

8-6
8. FRAME SETTING
Initial (origin search)
Initial (origin search)
This setting performs origin search at turning on the power to return the frame to the
position where the power was shut off.
1.
Switch to “FRAME SETTING”.
“Initial” operation searches the center
of the embroidery frame.
Origin of frame differs depending on
frame type.
2.
Switching of item to be displayed
3.
Selection of the setting value
Setting value: ON/OFF
ON: To search the origin when the
power switch is turned “ON”
OFF: Not to search origin
4.
Set
5.
Completion
When changing origin search to
“ON”, the screen will return to the
start screen.
Pressing “SET” will cause the
machine to perform origin search and
to call embroidery start screen.
“INITIAL” operation is required in
the following cases:
1. Frame type has been changed
2. When the power was shut off in the
middle of embroidering
3. When installing each software from
floppy disk
4. When installing PANEL software from
PC
JZ05
**** EMB START ****
TAJIMA12.DST 1
0/ 1027
01/15: 23456789AB<D>
1 Setting
Frame
*** FRAME SETTING **
1 MANUAL SPD 1
2.OFFSET MANUAL
3.ORIGIN RTN MANUAL
.
Frame
Position
*** FRAME SETTING **
3.ORIGIN RTN MANUAL
4.FRAME MODE CAP
5 INITIALIZE OFF
.
Frame
Position
*** FRAME SETTING **
3.ORIGIN RTN MANUAL
4.FRAME MODE CAP
5 INITIALIZE ON
.
Set
** TEJT2-C series **
FRAME FLAT
INITIAL ON <D>