Taiden HCS-4100MC/50, Installation And Operating Manual

Page: 31 / 60

23
23. “Select Master/Slave Mode”
If two CMU are installed in one system, they are set as
“Master Mode” and “Slave Mode” separately.
a). Press the “ Õ / Ö ” button to select “Master” or
“Slave”:
ƒ If “
Master Mode
” is selected, press the “MENU”
button to confirm and return to upper level menu;
ƒ
If “
Slave Mode
” is selected, press the “MENU”
button to confirm and go to step b);
b). Press the “ Õ / Ö ” button to select “Enable” or
“Disable”;
ƒ If
“Enable”
is selected, slave CMU will backup
master CMU automatically during the meeting
process. If master CMU stops, slave CMU will
switch automatically to master mode and act as
master CMU;
ƒ If
“Disable”
is selected, slave CMU will backup
master CMU automatically in the meeting
process. If master CMU stops, slave CMU will
NOT switch to master mode;
c). Press the “MENU” button to save and return to
upper level menu.
24. “Infrared MU Setting”
a). Press the “ Õ / Ö ” button to select “On” or “Off”;

If “
Off
” is selected, press the “MENU” to save
and return to upper level menu;

If “
On
” is selected, press the “MENU” button to
go to step b);
b). Setup infrared MU IP address, the same as 2.4.1 .
25. “Sampling Rate Setting”
Select sample rate between 32 kHz and 48 kHz.
If “48 kHz”
a). Press the “ Õ / Ö ” button to select “32 kHz” or “48
kHz”;
b). Press the “MENU” to save and return to upper level
menu.
26. “Close Loop Setting”
Enable/disable ring connection.
a). Press the “ Õ / Ö ” button to select “Yes” or “No”;
■ If “
Yes
” is selected, all contribution units can be
“daisy-chained” into a ring connection topology;
■ If “
No
” is selected, all contribution units can only
be “daisy-chained”;
b). Press the “MENU” button to save and return to
upper level menu.
27. “Headphone Volume Reduction”
If a headphone is plugged howling may happen when
the microphone is activated. “Headphone volume
reduction” function is used to suppress howling. If
enabled, the headphone audio signal will decrease
automatically by 18 dB.
a). Press the “
Õ / Ö ” button to select “Yes” or “No”;
b). Press the “MENU” button to save and return to
upper level menu.