TAC VISTA Xenta OP, Handbook

Page: 28 / 46

4 Dialogs with TAC Xenta 100 TAC Xenta, TAC Xenta OP
28 (46) TAC AB, July 2007
04-00065-01-en
Check that the LED on the Wall Module will flash for some 10 seconds
or that the red Service LED turns on and then off after a couple of sec-
onds, on the connected controller.
If contact is established without the LED flashing, Xenta OP has con-
nected to another node in the network. In this case disconnect Xenta OP
and then reconnect.
Wait for the display.
Xenta 100 is:
Configured
Press <DOWN> to
continue
Press the key and wait for a display looking like:
Xenta 103v1.00-10
103/A/v10003
units as SI [^]
NV index? 000
The first two lines, showing software versions, are displayed the first
time only.
The third line shows which unit system is used, when SNVT values are
presented in the OP menus.
The key toggles between SI (metric) and US Imperial (Inch-Pound)
units.
From this display (normally only lines 3-4 appear) the different Net-
work Variables can be selected.
4.3 Setting the Node State in TAC Xenta 100
When the display
Xenta 100 is:
Configured
Press <DOWN> to
continue