42
Chapter 04:
Using Your Sahara NetSlate with Windows XP
7.
If DHCP is used on your
network, tap “Obtain an IP
address automatically” and
“Obtain DNS server address
automatically”. Otherwise,
enter the correct IP and DNS
server addresses by selecting
the two options that begin
with “Use the following…” If
you are unsure of which
option to use, contact your
network administrator or
your Internet Service
Provider (ISP).
8.
After entering the correct the information in the “Internet
Protocol (TCP/IP) Properties” window, tap “OK” to accept
your changes and close the window. Tap “OK” in the “Local
Area Connection Properties” window to finish.
Using Both DHCP and a Static IP Address
If you are using alternating networks with either DHCP or static
IP addressing, you can use alternative settings that will enable
simultaneous configurations of both DHCP and a static IP. This
will allow you to connect to both of the networks without having
to reconfigure each time you want to switch.
There are a few different
networking protocols
used by Windows
(NetBIOS and SPX/IPX are
two examples). Unless
otherwise instructed
by your network
administrator, TCP/IP is
the only protocol that
needs to be installed.
Summary of Contents for Sahara NetSlate a230T
