TA Instruments TMA 2940 CE, Operator'S Manual, Page: 62 / 178

Installation
TA I
NSTRUMENTS
TMA 2940 CE 2–26
Starting the 2940 CE
Allow the TMA to warm up for at least 30
minutes before performing an experiment.
1. Check all connections between the TMA
and the controller. Make sure each compo-
nent is plugged into the correct connector, as
described in this chapter.
2. Turn the instrument
POWER
switch to the
ON ( ) position. The instrument will run an
internal confidence test each time you turn
on the power.
3. Watch the instrument display during the
confidence test for any messages that may
be indicated. Confidence test definitions are
given in Chapter 6.
After the confidence test has finished, the screen
will briefly display the system status, indicating
the amount of data storage memory available
and the GBIP address. Next follows the copy-
right display, and then the standby display, shown
in the figure on the next page.
4. Bring the instrument online with the TA
controller.
NOTE: