TA Instruments TMA 2940 CE, Operator'S Manual, Page: 106 / 178

Using Your Options
TA I
NSTRUMENTS
TMA 2940 CE 4–18
Accessory
Installation
The flexure accessory uses a special flexure
probe and sample platform, and the standard
stage.
1. Remove the existing probe as instructed on
page 2-18.
2. Install the standard stage, if it is not already
in place. (For instructions on installing the
stage, refer to page 2-13).
3. Install the flexure probe in the same manner
as the standard expansion and penetration
probes, using the procedure on page 2-17.
4. Change the instrument mode, if needed.
Calibration
The flexure probe should be calibrated as you
would normally calibrate any of the standard
probes. See the instrument control software
online documentation for details.