Product Name: MOBILMET 763
Revision Date: 05Sep2007
Page 3 of 9
______________________________________________________________________________________________________________________
In the event of a spill or accidental release, notify relevant authorities in accordance with all applicable
regulations. In the event of a spill or accidental release, notify relevant authorities in accordance with all
applicable regulations. US regulations require reporting releases of this material to the environment which
exceed the applicable reportable quantity or oil spills which could reach any waterway including intermittent dry
creeks. The National Response Center can be reached at (800)424-8802.
SPILL MANAGEMENT
Land Spill:
Stop leak if you can do it without risk. Recover by pumping or with suitable absorbent.
Water Spill:
Stop leak if you can do it without risk. Confine the spill immediately with booms. Warn other
shipping. Remove from the surface by skimming or with suitable absorbents. Seek the advice of a specialist
before using dispersants.
Water spill and land spill recommendations are based on the most likely spill scenario for this material;
however, geographic conditions, wind, temperature, (and in the case of a water spill) wave and current direction
and speed may greatly influence the appropriate action to be taken. For this reason, local experts should be
consulted. Note: Local regulations may prescribe or limit action to be taken.
ENVIRONMENTAL PRECAUTIONS
Large Spills: Dike far ahead of liquid spill for later recovery and disposal. Prevent entry into waterways,
sewers, basements or confined areas.
SECTION 7
HANDLING AND STORAGE
HANDLING
Avoid breathing mists or vapors. Small metal particles from machining may cause abrasion of the skin and may
predispose to dermatitis. Prevent small spills and leakage to avoid slip hazard.
Static Accumulator:
This material is a static accumulator.
STORAGE
Do not store in open or unlabelled containers.
SECTION 8
EXPOSURE CONTROLS / PERSONAL PROTECTION
Exposure limits/standards for materials that can be formed when handling this product:
When mists / aerosols
can occur, the following are recommended: 5 mg/m³ - ACGIH TLV, 10 mg/m³ - ACGIH STEL, 5 mg/m³ - OSHA PEL.
NOTE: Limits/standards shown for guidance only. Follow applicable regulations.
ENGINEERING CONTROLS
The level of protection and types of controls necessary will vary depending upon potential exposure conditions.
Control measures to consider:
No special requirements under ordinary conditions of use and with adequate ventilation.
