INSTRUCTION MANUAL
8
Check damaged parts
– Before further use of tool, a guard or other part that is damaged
should be carefully checked to determinate that it will operate properly and perform
its intended function. Check for alignment of moving parts, binding of moving parts,
breakage of parts, mounting, and any other conditions that may affect its operation.
A guard or other part that is damaged should be properly repaired or replaced by an
authorized service unless otherwise indicated elsewhere in this instruction manual. Have
defective switches replaced by an authorized service. Do not use tool if switch will not
turn it on and off.
Have your tool repaired only by T-DRILL
– This electric tool is in accordance with the
relevant safety requirements. Repairs should be carried out only by certified persons
using original spare parts; otherwise, this may result in considerable danger to the user.
Keep tools away from items that may be damaged by magnets
– The motor contains
a powerful magnet that may damage magnetic tape, credit cards, computer disks and
watches.
Use ear protectors
. During operation the noise level of the collaring machine may exceed
95dB(A).
The vibration exercised on the operator’s hand is less than 2.5 m/s.
2.2.1 T-65B BATTERY AND CHARGER SPECIFIC WARNINGS
L
DANGER! To reduce the risk of injury or explosion, never burn or
incinerate a battery pack even if it is damaged, dead or completely
discharged. When burned, toxic fumes and materials are created.
L
DANGER! Charge only MILWAUKEE 28 Volt Lithium-Ion battery packs
in MILWAUKEE 28 V Li-ion battery chargers. Other types of batteries may
cause personal injury and damage.
L
DANGER! To reduce the risk of injury, always unplug the charger
and remove the battery pack from the charger before performing any
maintenance. Never disassemble the battery pack or charger. Contact a
MILWAUKEE service facility for ALL repairs. To reduce the risk of injury and
damage, never immerse your battery pack or charger in liquid or allow a
liquid to flow inside them.