COLLARING MACHINE
21
T-65CU
7. Pull the support legs out and place the
tube support firmly onto the point where
the tee is to be formed on the tube, as
shown on the illustration. Press the tube
support with the thumb against the tube and
twist the machine counterclockwise at the
handle of the tool. This centers the T-DRILL
head onto the tube.
8. Start the tool by pressing the trigger and drill until the bit has fully penetrated into the
tube. Release the trigger - the machine will stop.
¨
NOTE! If the tool does not have enough power to drill – select the low
speed I and continue drilling. This may be necessary if a long extension
cord is used.
9. Extend the forming pins on the T-DRILL
head by pressing the conical cover towards
the tool and rotating it counterclockwise
until the T-DRILL head locks into the tee
forming position.
Do not extend the forming pins while
the motor is running!
10. Select low speed I by turning the selector
knob. (Always use low speed (I) when
forming the outlet, consult capacity chart in
section 11.1 for options.) Engage the feed
mechanism as shown. If it does not engage
smoothly, rotate the motor by “pumping”
the trigger.
