Synway Information Engineering Co., Ltd
SMG-D Series Analog Gateway User Manual (Version 2.0.0)
Page 23
Communicate
without Network
Mode
Sets the mode for the communications without network, two options available: Auto
Search Idle Channel and Use Current Route Setting, with the default value of
Auto
Search Idle Channel
. In the mode of Auto Search Idle Channel, the gateway will
search an idle FXO port to route the call once the network is disconnected; in the
mode of Use Current Route Setting, the gateway will search an escaping channel
according to the settings of Tel->IP route.
Two Stages Dialing
Mode
Sets whether it is necessary to perform the two-stages dialing operation to call the
remote end via an FXO port. By default this feature is disabled.
Avoid Being
Detected as Flash
Signal by PBX
Once this feature is enabled, after hanging up a call, the FXO channel will be
compelled to stay idle for a while before making a new call outside, which helps
avoid the pick-up signal being detected as a flash signal by the PBX. The default
value is
enabled
.
Delay after Dial
Sets the delay to send the CalleeID to PBX after you pick up and dial. Range of
value: 400~30000, calculated by ms, with the default value of 6000.
Delay to Send 200
OK to IP Side
Once this feature is enabled, the gateway will delay to send 200 OK message to the
IP side. The default value is
disabled
.
Open Session In
Advance
Once this feature is enabled, the gateway will reply the 183 message when the FXO
port is making an outgoing call; otherwise, it will reply the 180 message. This item is
valid only when Polarity Reversal is enabled. The default value is
enabled
.
Priority Rule
Sets the priorities for number attribution and manipulation. The default setting is
After Manipulation.
Remove Prefix 0 or
Area Code
Sets whether to remove the prefix 0 or the area code from the call number when the
CalleeID is a local number. By default it is disabled.
Add Prefix 0
Sets whether to add the prefix 0 to the call number when the CalleeID is not a local
number. By default it is disabled.
Local Area Code
Sets the local area code.
High Frequency Call
Limit
Sets whether to limit the call frequency for FXO call out. By default it is disabled.
Callout Count Limit
Set the limit on the number of FXO outbound calls. The default value is 0, which
means no limit.
Callout Time LImit
Limit the length of the FXO outbound call. The length of the call is randomly set in
the specified range, calculated by second. The default range is 0-5 seconds.
Call Type
Sets the call type for call restriction. The default setting is Any Call.
Maximum Call Times
Set the maximum number of allowed outgoing calls during the cycle. The default
value is 0, which means no limit.
Cycle Time
Sets the period for call restriction in minutes. The default value is 60 minutes.
Call Type
Set the call type for call restriction. The default setting is Any Call.
After configuration, click
Save
to save your settings into the gateway or click
Reset
to restore the
configurations. If a dialog box pops up after you save your settings asking you to restart the
system, do it immediately to apply the changes. Refer to
for detailed instructions.
3.5.3 Tone Detector
On the Tone Parameters setting interface, at most ten pieces of tone parameters are allowed to
