Synway Information Engineering Co., Ltd
SMG-D Series Analog Gateway User Manual (Version 2.0.0)
Page 14
is to set the RTP port and the payload type.
3.4.1 SIP
On the SIP settings interface you can configure the general SIP parameters. After configuration,
click
Save
to save your settings into the gateway or click
Reset
to restore the configurations. If a
dialog box pops up after you save your settings asking you to restart the system, do it immediately
to apply the changes. Refer to
for detailed instructions. The table below explains the items
on the interface.
Item
Description
SIP Address
IP address of SIP signaling, using LAN 1 by default.
SIP Port
Monitoring port of SIP signaling. The value range of it must be greater than 1024 and less
than 65535, with the default value of 5060.
Register Status
Registration status of the gateway. When
Register Gateway
is set to
No
, the value of this
item is
Unregistered
; when
Register Gateway
is set to
Yes
, the value of this item is either
Failed
or
Registered
.
Register Gateway
Sets whether to register the gateway as a whole. The default value is
No
. Only when this
configuration is set to
Yes
can you see the configuration items
SIP Account
and
Password
.
SIP Account
When the gateway initiates a call to SIP, this item corresponds to the username of SIP.
Password
Registration password of the gateway. To register the gateway to SIP, both configuration
items
SIP Account
and
Password
should be filled in.
Authentication
Username
Authentication username for registration.
Registrar IP Address
Address of the registry server for the gateway to register.
Registrar Port
Signaling port of the registry server.
Spare Registrar
Server
Check the enable checkbox to enable the spare registrar server. By default, it is
disabled
.
Spare Registrar IP
Address
Address of the spare registry server for the gateway to register. The gateway will enable the
spare registrar server if the master registrar server has no reply, or the master server is
detected with no response in case the item
Detection Server Cycle
is enabled.
Spare Registrar Port
Signaling port of the spare registry server.
Register Interval
Time
The registration interval between different ports, in milliseconds, with the value range of
0-1000.
Registry Validity
Period
Validity period of the SIP registry. Once the registry is overdue, the gateway should be
registered again. This configuration item is valid only when
Register Gateway
is set to
Yes
.
Range of value: 10~3600, calculated by s, with the default value of 600.
Multi-Registrar
Server Mode
Tick the checkbox before to enable the multi-registrar server mode. By default, it is
disabled
.
SIP Transport
Protocol
There are three modes
UDP
,
TCP
and
TLS
available for running the SIP protocol. The
default value is
UDP
.
SRTP
Sets whether to enable SRTP for the gateway to call out.
Switch Signal Port if
SIP Registration
Failed
If the SIP registration fails, the SIP signaling port N will switch to N+1 for a new registration.
It will continue until the registration succeeds. The default value is
disabled
.
