Synway SMG-D Series, User Manual

Page: 11 / 70

Synway Information Engineering Co., Ltd
SMG-D Series Analog Gateway User Manual (Version 2.0.0) Page 6
Chapter 2 Quick Guide
This chapter is intended to help you grasp the basic operations of the SMG analog gateway in the
shortest time.
Step 1: Confirm that your packing box contains all the following things.
 SMG Series Analog Gateway *1
 Angle Bracket *2, Rubber Foot Pad *4, Screw for Angle Bracket *8
 220V Power Cord *1, External 12V Power Adapter *1 for SMG-8D gateway
 Warranty Card *1
 Installation Manual *1
Step 2: Properly fix the SMG analog gateway.
If you do not need to place the gateway on the rack, simply fix the 4 rubber foot pads. Otherwise,
you should first fix the 2 angle brackets onto the chassis and then place the chassis on the rack.
Step 3: Connect the power cord.
Make sure the device is well grounded before you connect the power cord. Check if the power
socket has the ground wire. If it doesn‟t, use the grounding stud on the rear panel of the device
(See Figure 1-4) for earthing.
Step 4: Connect the network cable.
Step 5: Connect the telephone line. The line from PSTN should be connected to FXO port;
the line from station should be connected to FXS port.
These series products provide RJ11 interfaces. You can use a common telephone line directly or
construct a telephone line by yourself according to Figure 2-1. Note that only the middle two cores
in the RJ11 jack are valid for use.
Figure 2-1
Step 6: Log in the gateway.
Enter the original IP address (LAN1: 192.168.1.101) of the SMG analog gateway in the browser to
go to the WEB interface of the gateway. The original username and password of the gateway are
both „admin‟. For detailed instructions about login, refer to
System Login . We suggest you change
the initial username and password via „System Tools

Change Password‟ on the WEB interface
as soon as possible after your first login. For detailed instructions about changing the password,
refer to
Change Password . After changing the password, you are required to log in again.
Step 7: Modify IP address of the gateway.
You can modify the IP address of the gateway via „System Tools  Network‟ on the WEB interface
to put it within your company‟s LAN. Refer to Network for detailed instructions about IP
modification. After changing the IP address, you shall log in the gateway again using your new IP
address.
Step 8: Make phone calls.
Note: For your easy understanding and manipulation, all examples given in this step do not
involve registration, that is, SIP initiates calls in a point-to-point mode.
Situation 1: Call from a station to another (Tel  Tel)