4-13
Spectrum24 RF Terminal Setup
Note: To cancel this operation, press <CLEAR>.
5. Press <ENTER> to erase the EEPROM. When complete, the program prompts for
the communications parameters.
6. Set the parameters to 38400 bps, 7 data bits, odd parity and no flow control. Press
<ENTER>.
Start Communications
1. The WWC 1040 displays:
Comm Parameters
Start? <ENT>
2. Press <ENTER> on the WWC 1040.
3. The WWC 1040 displays:
Comm Parameters
Receiving:
If the host is not ready or if the cable is not connected properly between the host
PC and the cradle, the WWC displays:
Awaiting DSR
4. Press <ENTER> on the host PC to start the download. The wrist computer displays:
Program loader
Receiving: XXXX
where XXXX indicates the download’s progress.
5. When the transmission is complete, the WWC 1040 displays:
Program loader
Status 0000
A status of 0000 (all zeros) indicates a successful transfer. If the status is other than
0000, check the cable connections between the host PC and the cradle and repeat the
process. If the problem persists, contact the Symbol Support Center for assistance.
Summary of Contents for WSS 1000
