Symbol WSS 1000, Product Reference Manual

Page: 112 / 133

C-7
Spectrum24 Network and Flash Disk Utilities
directed to it, but not by a broadcast message. If the switch is set to “Off”, the radio
is powered off when an application powers down the terminal because of inactivity.
The default setting is “On”.
To change the current Terminal Sleep Mode, use the
ÇÈ
keys to toggle between the
“On” and “Off” settings.
Press <ENTER> to effect the change. Press <CLEAR> to exit without changes.
8. Select Boot Mode from the main configuration menu. The Boot Mode screen is
displayed.
Figure C-9. Boot Mode Screen
If boot mode is set to “Manual Entry”, no configuration messages are broadcast to
the network. The current values of the network parameters which are saved in the
radio’s flash, are used to connect to the network. “Manual entry” is the default.
If boot mode is set to “Boot” when the WSS 1040 is initialized, a TCP/IP BOOTP
request message is broadcast to the network. Any boot servers on the network should
respond if configured to do so. The terminal accepts the first valid response received.
The response contains an IP address for the terminal’s use, and optionally, other
network parameters. Parameters received in this BOOTP response override any
parameters entered through CFG24.
If boot mode is set to “DHCP” when the terminal is initialized, the process is the
same as for BOOTP, except the Dynamic Host Configuration Protocol is used.
Symbol’s BOOTP program accepts setting the following network parameters from
the BOOTP and DHCP parameters:
Sub-net Mask
Default Router (first address from the router list)
Terminal IP Address
BOOT MODE
IP address from:
DHCP
ÇÈ
, Clear, Enter