C-8
WSS 1000 Product Reference Guide
To change the current boot mode setting, use the
ÇÈ
keys to toggle between the three
valid settings.
Press <ENTER> to effect the change. Press <CLEAR> to exit without changes.
9. Select Power Management from the main configuration menu. The Power
Management screen is displayed.
Figure C-10. Power Management Screen
If power management is set to PSP (default), the radio is powered up only when there
is traffic on the network. This mode adapts to the radio activity to determine how
long the radio is powered down. Because the radio is not always in a ready state
when a message is sent to it, using PSP mode slows response times.
If power management is set to CAM, the radio is always ready to receive. In this
mode, battery life is dramatically reduced. Because the WSS 1040 runs on a Lithium-
Ion battery, you can use this method, but it is not recommended.
To change the current power management setting, use the
ÇÈ
keys to toggle between
the two settings.
Press <ENTER> to effect the change. Press <CLEAR> to exit without changes.
10. Select Exit from the main configuration menu and press <ENTER> to exit the
configurator and get to a DOS prompt.
11. Cold boot the WWC 1040 to re-initialize the terminal with the changed parameters.
POWER MANAGEMENT
Radio Power Mode
PSP
ÇÈ
, Clear, Enter
Summary of Contents for WSS 1000
