Symbol WSS 1000, Product Reference Manual

Page: 111 / 133

C-6
WSS 1000 Product Reference Guide
To change the current Terminal IP Address, backspace over the current value and
type a new value in decimal form. Each part of the four-part address must be in the
range 0 to 255.
Press <ENTER> to effect the change. Press <CLEAR> to exit without changes.
6. Select Diversity from the main configuration menu. The Diversity screen
is displayed.
Figure C-7. Diversity Screen
If Diversity is set to “Yes”, the radio firmware attempts to use both antenna ports for
communications. This setting gives better communications if two antennas are being
used with the radio, but distinctly worse communications if only one antenna is used.
The WSS 1040 has only one antenna; be sure to set Diversity to “No”.
To change the current Diversity setting, use the
ÇÈ
cursor keys to toggle between the
settings “Yes” and “No”.
Press <ENTER> to effect the change. Press <CLEAR> to exit without changes.
7. Select Terminal Sleep Mode from the main configuration menu. The Terminal Sleep
Mode screen is displayed.
Figure C-8. Terminal Sleep Mode Screen
If this switch is set “On”, the radio is not powered off when an application powers
down the terminal because of inactivity. The terminal can be awakened by a message
DIVERSITY
2 antennas (Yes/No)
Yes
ÇÈ
,
#
Clear, Enter
TERMINAL SLEEP MODE
Radio state:
On
ÇÈ
,
#
Clear, Enter