Symbol SE 923, Integration Manual

Page: 67 / 238

5-15
Parameter Menus
Time-out Between Same Symbol
Parameter # 0x89
When in Continuous triggering mode, this parameter sets the minimum time that must elapse
before the scanner decodes a second bar code which is identical to one which has just been
decoded. This reduces the risk of accidently scanning the same symbol twice. It is
programmable in 0.1 second increments from 0.0 to 9.9 seconds.
To set a time-out between same symbol, scan the bar code below. Next scan two numeric bar
codes beginning on page 5-102 that correspond to the desired time-out. Times less than 1.0
second must have a leading zero. For example, to set a time-out of 0.5 seconds, scan the bar
code below, then scan the “0” and “5” bar codes. If you make an error, or wish to change
your selection, scan the
CANCEL bar code on 5-104.
TIME-OUT BETWEEN SAME SYMBOL