Symbol SE 923, Integration Manual

Page: 63 / 238

5-11
Parameter Menus
Aim Duration
Parameter # 0xED
When a scanner with an aim mode (see Table 6-10 on page 6-27) is triggered either by a
trigger pull, or a
START_DECODE command, this parameter sets the duration the aiming
pattern is seen before a a scan attempt begins. It does not apply to the aim signal or the
AIM_ON command. It is programmable in 0.1 second increments from 0.0 to 9.9 seconds.
No aim pattern is visible when the value is 0.0. For more information on the use of this
parameter, see the
AIM_ON command on 6-7.
To set an aim duration, scan the bar code below. Next scan two numeric bar codes beginning
on page 5-102 that correspond to the desired aim duration. Times less that 1.0 second must
have a leading zero. For example, to set an aim duration of 0.5 seconds, scan the bar code
below, then scan the “0” and “5” bar codes. If you make an error, or wish to change your
selection, scan the
CANCEL bar code on 5-104.
AIM DURATION