TX3-CX-1NP Installation
1
LT-5997 Rev 3 January 2018
Subject to change without notice. See http://www.mircom.com for the latest information
TX3-CX-1NP Installation
These instructions explain how to install the TX3-CX-1NP and the TX3-P300-HA card reader
in the following TX3 units:
These units include 2 #6-32 x 1/2" screws for attaching the TX3-P300-HA card reader to the
inside of the door.
A.
Contents of Kit
Qty 1... TX3-CX-1NP
Qty 2... Nuts for attaching TX3-CX-1NP to the TX3 unit
Qty 1... USB cable for programming TX3-CX-1NP
Qty 1... USB flash containing TX3 software and manuals
B.
Mount TX3-CX-1NP
1. Mount TX3-CX-1NP on the two posts as shown in Figure 1.
2. Secure it with the provided nuts.
Figure 1
Mount TX3-CX-1NP
C.
Mount the TX3-P300-HA Card Reader
•
Secure the card reader to the plastic bracket on the inside of the door with the 2 #6-32 x 1/2"
screws that are included with the TX3 unit.
Note:
Do not use the cover that is included with the reader.
Note:
Install the reader with the LED facing out.
TX3-TOUCH-F15-B/C
TX3-200-8U-B/C
TX3-1000-8U-B/C
TX3-2000-8U-B/C
TX3-TOUCH-S15-B/C
TX3-200-8C-B/C
TX3-1000-8C-B/C
TX3-2000-8C-B/C
TX3-TOUCH-F22(-C)
TX3-TOUCH-S22(-C)
Nut
Nut
Card reader
connections
RJ45 connector for
Internet communication
and Power over Ethernet
DIP switches
Installing on a telephone entry unit
Installing on a Touch Screen
