TX3-CX-1NP Installation
2
LT-5997 Rev 3 January 2018
Subject to change without notice. See http://www.mircom.com for the latest information
Figure 2
Install the card reader with the LED facing out
D.
Set the RS-485 Address
•
Use DIP switches 1-6 (shown in Figure 1) to set the RS-485 network address.
Figure 3
Set the RS-485 address
Note:
You must set the RS-485 address even if you are not using RS-485.
•
Keep DIP switch 7 off.
•
Set DIP switch 8 off to get an IP address from the DCHP server.
•
Set DIP switch 8 on to set a fixed IP address using the TX3 Configurator software.
For more information and the complete list of RS-485 addresses, see LT-980, the TX3 Card
Access System Manual, on the Mircom website (www.mircom.com) or the USB flash.
E.
Connect the Card Reader
Card reader requirements
Card readers must meet the following minimum requirements in order to be compatible with
Mircom’s Card Access System:
• 26 bit standard SIA protocol
Table 1:
Connections for the TX3-P300-HA reader
Color of Reader Wire
Terminal on TX3-CX-1NP
Green
DATA0
Black
GND
White
DATA1
Blue
BEEP
Brown
LED (R)
Orange
LED (G)
Red
PWR
