Installation and connections
Page 18/55
SYCLOPE TERE’O Touch XL
®
Installation, starting, and programming instructions
●
Self-powered relays outputs connection Chlorine/Bromine P4
The self-powered relays outputs P4 (Primary supply voltage = voltage available on P4) used for
chlorine/bromine parameter regulation.
►
Strip the 3 wires of the power cable of the dosing device on 7mm
►
Pass the 3-point cable through a cable gland
►
Connect the phase on
L1 (43)
and the neutral on
N (44)
of the P4 mains terminal
block
►
Connect the earth on
PE (45)
of the P4 mains terminal block
►
Tighten the cable gland to seal
9)
Potential-free relay connections (P2)
The potential-free relay outputs can be used as alarm relays, regulation or be controlled in Timer mode
as required.
Use a 2-wire cable with a section appropriate for the voltage and current.
Remove the protective sheath.
Strip wires on 7mm.
Pass the cable through a cable gland.
Connect a cable on the midpoint
COMMON (41)
of the terminal block
Connect the second cable on the
WORK (40)
of the terminal block or on the
REST (42)
depending on the function to be performed.
Tighten the cable gland to seal.