97
DOME TIC OVEN
FI
T
TED EQ
UIP
MEN
T
Truma Combination Boiler Control Panel and
appliance instructions
Please read the user instructions before using
the heating system. The instructions include
warnings regarding the safe use of the system,
and no liability whatsoever can be accepted
for damage or injury resulting from failure to
observe the instructions.
The heating system can be controlled by a
Truma CP+ controller, or the Swift Command
control panel, App., or remote control system.
For Swift Command functions please see the
Swift Command literature and details within
this handbook.
For use of the CP Plus controller, and general
user instructions for the heating system
appliance, please read the Truma information
available at the following locations:
CP Plus Controller
https://www.truma.com/downloadcenter/ cp_
plus_installation_operating_de_gb_fr_ it.pdf
Combi 4 Gas/Electric and Combi 6 Gas/
Electric appliances
https://www.truma.com/downloadcenter/
combi_e_cp_plus_ready_operating_de_gb_
fr_it_nl_dk_se.pdf
If you are unable to view the documents on
line, please contact the supplier, your dealer or
Swift for an electronic or paper copy.
Electrical Operation of Truma Combination
Boiler
Before the heating system is used for heating
using electrical (230v) energy, the 230v
isolation button on the Sargent Power Supply
Unit must be switched ON, as shown in the
image below. To confirm a supply is available,
the button will be illuminated when a power
supply (mains hook up) is connected and the
button is ON.
Troubleshooting instructions (Combi heater)
In the event of a problem occurring, a warning
or error code will be displayed on the Truma
CP Plus control panel, along with a warning
triangle. Further warning information will also be
displayed on the Swift Command control panel.
The Truma combi boiler (heater and water) has
two styles of error code warnings which are
shown on the CP+ display panel. Depending
on the nature of the fault, the boiler will
require resetting in a slightly different manner,
depending on the fault.
• Solid error warning code
• Flashing error warning code
Before trying to reset any faults please check
that the 12v supply is on, and depending on
which energy source is going to be used for
heating, either mains electricity is available
and switched on, and/or that the gas bottle is
open and ready to dispense gas.
The following table on the next page describes
causes and remedies to the various fault codes
that may be displayed on the Truma control
panel.
Once the fault has been rectified the fault can
be reset via the control panel
Summary of Contents for Select 122 2020
