Swift Group Select 122 2020, Owner'S Handbook Manual

Page: 34 / 154

33
INFL ATION PROCEDURE
Inflation Procedure
CAUTION: Wear the protective gloves
provided together with the quick tyre repair
kit.
CAUTION: Affix the adhesive label in an easy-
to-see position for the driver as a reminder
that the tyre has been treated with the quick
tyre repair kit. Drive carefully, particularly
on bends. Do not exceed 80 km/h. Do not
accelerate or brake suddenly.
CAUTION: If the pressure falls below 3
bars, do not drive any further: the Fix &
Go automatic quick tyre repair kit cannot
guarantee proper hold because the tyre is too
much damaged. Contact a Fiat Dealership.
CAUTION: You must inform the dealership
that the tyre has been repaired using the
quick tyre repair kit. Give the booklet to
the personnel who will be handling the tyre
treated with the repair kit.
CAUTION: If different tyres from the ones
supplied with the vehicle are used, it may
not be possible to carry out the repair. If the
tyres are replaced, it is advisable to use those
approved by the manufacturer. Consult a Fiat
Dealership.
• Pull the handbrake. Unscrew the tyre valve
cap, take out the filler hose A (Fig. C) and
tighten the ring nut B on the tyre valve;
• Insert the plug E (Fig. E) in the nearest 12V
power socket and start the engine. Turn
the selector D (Fig. D) anti-clockwise to the
repair position. Activate the kit by pressing
the on/off switch. Inflate the tyre to the
pressure specified in the “Inflation pressure”
paragraph, in the “Technical Data” chapter;
For a more accurate reading, it is advisable to
check the pressure reading on the pressure
gauge F (Fig. D) with the compressor off and
without moving the centre selector from the
repair position
• If after 10 minutes it is still impossible to
reach at least 3 bar, release the transparent
filler pipe from the valve and take out the
12 V plug, then move the vehicle forwards
by about 10 metres in order to distribute
the sealing fluid inside the tyre evenly, then
repeat the inflation operation;
• If after this operation you still cannot reach at
least 3 bar after 10 minutes, do not resume
driving because the tyre is too damaged and
the quick tyre repair kit cannot guarantee
suitable sealing. Contact a Fiat Dealership;
• If the tyre reaches the pressure specified
in “Inflation pressure” paragraph in the
“Technical Data” section of the Fiat user
manual start driving immediately;
Fig C
Fig D
EN R
OU
TE