Swift Group Select 122 2020, Owner'S Handbook Manual

Page: 80 / 154

79
Warning When Type
Fresh water
level low
With pump turned on and fresh
water level low (less than 25% full)
Only available when an on-board
tank is fitted.
Message on screen and 60 second
audible beep
Waste water
level full
With pump turned on and waste
water level full. Only available when
an on-board tank is fitted
Message on screen and 60 second
audible beep
Leisure battery
voltage low
W
ith control panel power on and
leisure battery selected (as active
battery) and the voltage level falls
below 10V
Message on screen and 60 second
audible beep
With control panel power on and
leisure battery selected (as active
battery) and the voltage level is
below 9
Message on screen and 60 second
audible beep. If no action taken after 30
seconds then the system will switch the
power off to prevent severe discharge of
the battery
Note: This is an emergency cut off level to protect the battery from severe
damage. You should not rely on this cut off level during normal operation, but
manage your power consumption to a discharge level of 11.5V or above. This
cut off only applies to power drawn from the battery by the leisure equipment
that is controlled by the control panel power switch; it will not protect the
battery from discharge by permanently connected equipment.
Leisure
battery
voltage high
With control panel power on or
off and leisure battery is selected
(as active battery) and the voltage
level rises above 15V
Message on screen and repeated beeps
from the control panel. The power is
automatically turned off. The beeping will
not stop until the fault is cleared.
SWIF T COMMAND
POWER CONTROL SYSTEM
2.20 System Warnings
The system incorporates a number of warnings that are active at specific times. These are
summarised below, and also covered by relevant sections of this manual.
When a warning is active a warning box will appear on the control panel screen containing a
description of the warning along with an audible beeping sound.
ELEC
TR
IC
AL S
YS
TEMS
2.19 Electric Step Operation
On vehicles fitted with an electric step, this is
operated by a button near the entry door. Press
and release the button to move the step in or
out. One press of the button will move the step
out; a further press will move the step in again.
If the engine is started the step will move in
automatically, after a short warning buzzer. If
this operation fails due to an obstacle a buzzer
will sound continuously to warn that the step is
still out, and therefore requires your attention.