103
FI
T
TED EQ
UIP
EM
N
T
DOME TIC OVEN
Controls
The following symbols indicate the burner
corresponding to the control knob.
This symbol is placed next to the hob burner
knobs. Full dot refers to the corresponding hob
burner.
The following symbols indicate the burner
regulation corresponding to the knob position.
Note:
Different models may have different
knobs and different symbols.
GAS OFF
HIGH FLAME
LOW FLAME
Other symbols
PUSH BUTTON
ELECTRONIC IGNITION
Selecting burner
WARNING:
The flame must never extend
beyond the edge of the pan. Centre the pan
over the burner ensuring stability on the pan
support.
Burner
Pan Diameter
AUXILIARY
Ø 47mm
from 6 to 16cm
SEMI-RAPID
Ø 62mm
from 16 to 22cm
RAPID
Ø 0 77mm
from 16 to 22cm
Electronic Ignition Hob
(Depending on model) Hob!
WARNING:
Make sure there are no pans
or other any objects on the burners when
igniting.
To ignite burner, gently push-in and turn the
control knob to position HIGH FLAME and
maintaining the knob pushed at the same time
press the electronic ingnition pushbutton. Once
the burner is alight maintain the knob in this
position for a few seconds to ensure the flame
remains alight.
CAUTION:
If the burner does not ignite
immediately repeat ignition after having
followed each step below:
•
Turn the knob to “small flame”
• Proceed with manual ignition
•
Check there is sufficient gas in the gas
bottle.
If the appliance still does not ignite shut
off the gas supply at the main gas tap and
contact your local dealer.
Manual Ignition Hob
Manual ignition when the appliance is not fitted
with the electronic ignition feature or in the
event of failure in the electronic ignition.
WARNING:
Make sure there are no pans
or other any objects on the burners when
igniting.
To ignite burner, gently push-in and turn the
control knob to position HIGH FLAME and
maintaining the knob pushed at the same time
light the burner with a match or gas lighter.
Once the burner is alight maintain the knob in
this position for a few seconds to ensure the
flame remains alight.
WARNING:
If the burner does not ignite
immediately check there is sufficient gas in
the gas bottle. If the appliance still does not
ignite shut off the gas supply at the main gas
tap and contact your local dealer.
Summary of Contents for Select 122 2020
