SVP HDT-70, Manual

Page: 37 / 201

37
HDT-70_H.264 High Definition Camera Transmitter
MANUAL V9.0
3.3 LEDs
The HDT-70 transmitter has 3 LEDs on its front panel that show the
information detailed below.
The ON/OFF provides the following information:

If the LED is off, the equipment is not being fed.

If the LED flickers in red, there is power into the equipment but it is
turned off.

The LED lights up in green when the equipment is turned on.
The ALARM LED provides the following information:

The LED lights up in red when any alarm occurs.

The different alarms that can appear in the transmitter are:
- Voltage Low(<22 dBm).
- Temperature High.
- ASI Overflow: This alarm means that the input bitrate is higher than
the one that can be modulated due to the parameters configured
(constellation, FEC, GI...).

The different warnings that can appear in the transmitter are:
- No Video Input.
- No GPS.
The
STATUS LED :

The LED lights up when a change in the configuration of the device is
being processed.
MOD LED and CARRIER LED :

These LEDs light up when DVB-S2 transmission standard is being used.
Figure 3.9 HDT-70 LEDs
ON/OFF LED
ALARM LED
STATUS LED
MOD LED
CARRIER LED