SVP HDT-70, Manual

Page: 104 / 201

104
HDT-70_H.264 High Definition Camera Transmitter
MANUAL V9.0
2
Destination IP & Port:
In this option, the IP address and the port number of the device
to which data is sent must be configured. In case it is wanted to
send data to a multicast address just enter the desired multicast
address. So as to change the IP address and the port number,
first press the OK button and then, with the Up, Down keys
select the desired number. So as to change from one character
to another, press Right, Left keys. So as to save the value, press
OK button. (editable parameter)
3
FEC:
In this field, the Forward Error Correction can be enabled or
disabled. In case it is enabled, the number of columns and rows
can be configured pushing firstly the OK button and then, with
the Up, Down arrows, the number of columns and rows wanted
can be selected. If FEC option is enabled then, the only protocol
which can be used is RTP. (eligible parameter)
4
TP per IP:
In this field, the number of Transport Stream packets per IP
(from 1 to 7) can be configured. So as to select the desired
value, press the Right, Left buttons. (eligible parameter)
5
Protocol:
The type of protocol used for the communication can be RTP or
UDP. So as to select the desired protocol for the communication,
use Right, Left buttons. (eligible parameter)
6
TTL:
This field limits the lifetime of data. The Time to Live value (from
1 to 255) means the number of routers that a packet can reach
until that packet is discarded. So as to configure this value, first
press the OK button and then, with the Up, Down, and Right,
Left buttons select the desired value. So as to save the value,
press OK button. (editable parameter)
Table 3.37 IP Out menu options
When a parameter of the TS over IP menu options is changed, it
takes 30 seconds to the device to be configured and work again.