SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | [email protected]
SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | [email protected]
23
22
4.3 Interior Antennas
Mount the interior antenna(s) in the location(s) you selected when planning. Follow all instructions included with the
antenna(s) to ensure the installation(s) are done properly.
Here are a few reminders and essential steps:
• Dome antennas are mounted on the ceiling as close to the center of the desired coverage area as possible,
domed (convex) side pointing down.
• Flat panel antennas should be wall-mounted as close as possible to the center of the wall, or at one end of long
narrow space.
• Mount the antenna.
• Connect a length of cable to the antenna and tighten until hand-tight.
• If you are installing multiple antennas, run the cable to the splitter location and connect the cable to one of the
outputs on the splitter.
• Connect another length of cable to the input side of the splitter (if used) and run this cable to the BDA location.
• It is important to keep the cable runs equal or use taps to ensure a harmonious install.
CAUTION: VERIFY THAT ALL INTERIOR ANTENNAS MEET
THE SEPARATION REQUIREMENTS DESCRIBED IN THE
PREVIOUS CHAPTER, AND THAT NO ANTENNA IS AIMED
TOWARD THE EXTERIOR ANTENNA.
CAUTION: DO NOT CONNECT AN INTERIOR ANTENNA TO
THE SPLITTER INPUT.
Installation
4.4 Mounting the BDA
Mount the Guardian2 QR as follows:
• Verify that the selected location meets all criteria described in the previous chapter.
• Mount a 24 inch x 24 inch x 3⁄4 inch thick sheet of plywood on top of sheetrock, secured into wall studs where the
NEMA housing is to be placed. The plywood should be flush against wall.
• Once the plywood is secure, attach the NEMA housing to the plywood base using the screws provided. In most
installations, the housing will be oriented so the I/O ports are facing down.
• Connect the outdoor antenna cable to the signal booster connector port marked OUTSIDE and tighten the
connection.
• Connect the outdoor antenna cable to the signal booster connector port marked INSIDE and tighten the
connection.
CAUTION: DO NOT POWER ON THE BDA UNTIL
INSTRUCTED TO DO SO.
CAUTION: NEVER POWER ON THE BDA WHEN ANY
ANTENNAS ARE DISCONNECTED AS THIS COULD
DAMAGE THE BDA.
Installation
