Supero X9DRL-7F, User Manual

Page: 58 / 113

2-34
X9DRL-7F/X9DRL-EF Motherboard User’s Manual
JCOM2
JSD1
P1-DIMMD1
P2-DIMME1
P1-DIMMB1
P2-DIMMH1
P2-DIMMG1
P1-DIMMC1
P2-DIMMF1
COM1
JPW4
JTPM1
LAN2 LAN1
JPW1
JPW2
USB4
JPI2C1
JIPMB1
FAN5
FAN2 FAN3
FAN4 FANA
JPL1 JPL2
JVRM_I2C1 JVRM_I2C2
JPG1
JPS1
JWD1
JLED1
JMLED1
LEDS1
LEDM1
LED1C
LED2
JF1
T-SGPIO1
T-SGPIO2
6-SGPIO2
I-S
AT
A1
I-SATA0
L-SAS0
Battery
JL1
JPS2 JPS3
JOH1 JI2C1
JI2C2
SP1
JUIDB1
USB0/1
X9DRL-7F/EF
Rev.1.01
PCH SLOT3 PCI-E 2.0 X4 (IN X8)
CPU1 SLOT6 PCI-E 3.0 X8
CPU1
VGA
USB8/9 USB6/7
IPMI_LAN
CPU2
JPB1
6-SGPIO1
PCH SLOT2 PCI-E 2.0 X1
CPU1 SLOT4 PCI-E 3.0 X8
I-SATA2
I-SATA3
I-SATA4
P1-DIMMA1
FP CTRL
Intel PCH
LSI 2208
CTRL
BMC
JBT1
LAN
CTRL
LAN
CTRL
L-SAS7
I-SATA5
L-SAS6
L-SAS5
L-SAS4
JPME1
JBR1
BIOS
JSTBY1
L-SAS1
L-SAS2
L-SAS3
JPME2
FAN1
CMOS Clear
JBT1 is used to clear CMOS. Instead of pins, this "jumper" consists of contact pads
to prevent accidental clearing of CMOS. To clear CMOS, use a metal object such
as a small screwdriver to touch both pads at the same time to short the connection.
Always remove the AC power cord from the system before clearing CMOS.
Note 1.
For an ATX power supply, you must completely shut down the sys-
tem, remove the AC power cord, and then short JBT1 to clear CMOS.
Note 2. Be sure to remove the onboard CMOS Battery before you short
JBT1 to clear CMOS.
Note 3. Clearing CMOS will also clear all passwords.
A
B
A. Clear CMOS
B. Watch Dog Enable
Watch Dog Enable/Disable
Watch Dog (JWD1) is a system monitor that
will reboot the system when a software ap-
plication hangs. Close Pins 1-2 to reset the
system if an application hangs. Close Pins
2-3 to generate a non-maskable interrupt
signal for the application that hangs. See the
table on the right for jumper settings. Watch
Dog must also be enabled in the BIOS.
Watch Dog
Jumper Settings
Jumper Setting Definition
Pins 1-2 Reset (default)
Pins 2-3 NMI
Open Disabled