Supero SUPER S2DM3, User Manual

Page: 62 / 94

S
UPER S2DM3/S2DME Manual
4-6
BIOS
AMIBIOS checks for a <Del> key press and runs AMIBIOS
Setup if the key has been pressed.
Enabled
AMIBIOS does not test system memory above 1 MB.
AMIBIOS does not wait up to 40 seconds for a READY signal
from the IDE hard disk drive. If a READY signal is not
received immediately from the IDE drive, AMIBIOS does not
configure that drive. AMIBIOS does not wait for .5 seconds
after sending a RESET signal to the IDE drive to allow the IDE
drive time to get ready again. In Enabled, keyboard will be
bypassed.
Note: You cannot run AMIBIOS Setup at system boot, because
there is no delay for the "Hit <Del> to run Setup" message
.
Pri Master ARMD Emulated as
Pri Slave ARMD Emulated as
Sec Master ARMD Emulated as
Sec Slave ARMD Emulated as
The settings for these options are Auto, Floppy or Hard disk . If set to
Auto, the default emulation type depends on the ARMD drive: floppy for
LS120, Hard Disk for MO and Hard Disk for Iomega Zip.
1st Boot Device
2nd Boot Device
3rd Boot Device
The options for the 1st Boot Device are Disabled, 1st IDE-HDD, 2nd IDE-
HDD, 3rd IDE-HDD, 4th IDE-HDD, Floppy, ARMD-FDD, ARMD-HDD,
ATAPI CDROM, SCSI, Network
or
I
2
0
. The options for the 2nd Boot
Device are
Disabled, 1st IDE-HDD, 2nd IDE-HDD, 3rd IDE-HDD, 4th
IDE-HDD, Floppy, ARMD-FDD, ARMD-HDD, ATAPI CDROM or SCSI
.
The options for the 3rd Boot Device are
Disabled, 1st IDE-HDD, 2nd
IDE-HDD, 3rd IDE-HDD, 4th IDE-HDD, Floppy, ARMD-FDD, ARMD-HDD
or ATAPI CDROM .
1st IDE-HDD, 2nd IDE-HDD, 3rd IDE-HDD and 4th IDE-HDD are the four hard
disks that can be installed by the BIOS. 1st IDE-HDD is the first hard disk
installed by the BIOS, 2nd IDE-HDD is the second hard disk, and so on. For
example, if the system has a hard disk connected to Primary Slave and
another hard disk to Secondary Master, then 1st IDE-HDD will be referred to
as the hard disk connected to Primary Slave and 2nd IDE-HDD will be
referred to as the hard disk connected to the Secondary Master. 3rd IDE-
HDD and 4th IDE-HDD are not present. Note that the order of the initializa-
tion of the devices connected to the primary and secondary channels are
Primary Master first, Primary Slave second, Secondary Master third, and