Supero SUPER S2DM3, User Manual

Page: 44 / 94

2-16
S
UPER S2DM3/S2DME User's Manual
Installation
2-8 Parallel Port, Floppy/Hard Disk Drive, AGP
Port and SCSI Connections
Note the following when connecting the floppy and hard disk drive cables:
• The floppy disk drive cable has seven twisted wires.
• A red mark on a wire typically designates the location of pin 1.
Onboard LAN/NIC
Enable/Disable
Change the setting of jumper JP11
to enable or disable the onboard
LAN or NIC (Network Interface
Card) on your motherboard. See
Table 2-31 for jumper settings.
J u m p e r
Position
O p e n
C l o s e d
Definition
D i s a b l e d
E n a b l e d
Table 2-31
Onboard LAN/NIC
Enable/Disable
Jumper Settings (JP11)
Power Supply Failure
Alarm Enable/Disable
The system will notify you in the
event of a power supply failure.
This feature assumes that three
power supply units are installed in
the chassis, with one acting as a
backup. If you only have one or
two power supply units installed,
you should disable this with JP13
t o p r e v e n t f a l s e a l a r m s . S e e
Table 2-32 for jumper settings.
J u m p e r
Position
O p e n
C l o s e d
Definition
D i s a b l e d
E n a b l e d
Table 2-32
Power Supply Failure
Alarm Enable/Disable
Jumper Settings (JP13)
Host Bus ECC
Jumper JP5 is used to enable or
disable ECC (Error Correction and
Control) on the host (front side)
bus. See Table 2-30 for jumper
settings.
J u m p e r
Position
1-2
2-3
Definition
E n a b l e d
D i s a b l e d
Table 2-30
Host Bus ECC Enable/
Disable
Jumper Settings (JP5)