Supero SUPER S2DM3, User Manual

Page: 74 / 94

S
UPER S2DM3/S2DME Manual
4-18
BIOS
Chassis Fan1
Chassis Fan2
The above features are for PC Health Monitoring. The motherboards with
W83781D have seven onboard voltage monitors for the CPU core, CPU I/
O, +3.3V, +5V, -5V, +12V, and -12V, and for the four-fan status monitor.
OnBoard IDE
This option enables the IDE (Hard Disk Drive Controller) drives(s) on the
motherboard. The settings are Disabled, Primary, Secondary and Both .
OnBoard FDC
This option enables the FDC (Floppy Drive Controller) on the motherboard.
The settings are Disabled and Enabled .
OnBoard Serial Port1
This option specifies the base I/O port address of serial port 1. The
settings are
Disabled
,
3F8h
,
2F8h
,
3E8h
and
2E8h
.
OnBoard Serial Port2
This option specifies the base I/O port address of serial port 2. The
settings are Disabled , 3F8h , 2F8h , 3E8h and 2E8h .
Serial Port2 Mode
The settings for this option are Normal, IrDA SIR-A,. IrDA SIR-B,
ASKIR, Consumer and Raw IR . When set to anything but
Normal, the IR Duplex Mode becomes available and can be set to
either Half or Full .
Serial Port2 Duplex Mode
This option is enabled by the selection made in the previ-
ous Serial Port 2 Mode option. This makes the IR Duplex
Mode available, which can be set to either
Half
or
Full
.
Onboard Parallel Port
This option specifies the base I/O port address of the parallel port on the
motherboard. The settings are Auto (AMIBIOS automatically determines the
correct base I/O port address), Disabled , 378h , 278h and 38Ch .
Parallel Port Mode
This option specifies the parallel port mode. The settings are
Normal , EPP and ECP . When set to Normal, the normal parallel
port mode is used. Use Bi-Dir to support bidirectional transfers.
Use EPP (Enhanced Parallel Port) to provide asymmetric bidirectional