Supero SUPER S2DM3, User Manual

Page: 46 / 94

2-18
S
UPER S2DM3/S2DME User's Manual
Installation
AGP Pro Slot
The AGP Pro slot is backward compatible with AGP and 4xAGP graphics
cards, which have fewer pins than AGP Pro cards. Because of this,
care must be taken when installing a graphics card into this slot, as doing
so incorrectly can damage your motherboard. For AGP Pro cards, you
should remove the orange sticker covering one end of the slot. For other
cards, leave this sticker in place and make sure your card does not plug
into the section it covers. A general rule of thumb is to make sure your
card fills the center section of pins first, then the end toward the edge of
the motherboard if there are more. If the I/O shield of your card is flush
with the edge of the motherboard, the card should be inserted correctly.
AGP Pro Slot
E d g e o f m o t h e r b o a r d
IDE Connectors
There are no jumpers to config-
ure the onboard IDE connectors
J14 and J15. Refer to Table 2-
35 for pin definitions. You
must use the ATA66 cable in-
c l u d e d w i t h y o u r s y s t e m t o
benefit from the ATA66 tech-
nology.
Pin Number Function
1 Reset IDE
3 Host Data 7
5 Host Data 6
7 Host Data 5
9 Host Data 4
11 Host Data 3
13 Host Data 2
15 Host Data 1
17 Host Data 0
19 G N D
21 D R Q 3
23 I/O Write-
25 I/O Read-
27 I O C H R D Y
29 D A C K 3 -
31 I R Q 1 4
33 Addr 1
35 Addr 0
37 Chip Select 0
39 Activity
Pin Number Function
2 G N D
4 Host Data 8
6 Host Data 9
8 Host Data 10
10 Host Data 11
12 Host Data 12
14 Host Data 13
16 Host Data 14
18 Host Data 15
20 K e y
22 G N D
24 G N D
26 G N D
28 B A L E
30 G N D
32 I O C S 1 6 -
34 G N D
36 Addr 2
38 Chip Select 1-
40 G N D
Table 2-35
IDE Connector Pin Definitions
(J14, J15)