Supero SUPER S2DG2, User'S And Bios Manual

Page: 61 / 96

Chapter 5: Running Setup
5-3
5-1-2 Advanced CMOS Setup
Quick Boot
The Settings are Disabled or Enabled . Set to Enabled to permit AMIBIOS to
boot quickly when the computer is powered on. This option replaces the old
Above 1 MB Memory Test Advanced Setup option.
The settings are:
Setting Description
Disabled AMIBIOS tests all system memory. AMIBIOS waits
for up to 40 seconds for a READY signal from the
IDE hard disk drive. AMIBIOS waits for .5 seconds
after sending a RESET signal to the IDE drive to
allow the IDE drive time to get ready again.
AMIBIOS checks for a <Del> key press and runs
AMIBIOS Setup if the key has been pressed.
Enabled AMIBIOS does not test system memory above 1 MB.
AMIBIOS does not wait for up to 40 seconds for a
READY signal from the IDE hard disk drive. If a
READY signal is not received immediately from the
IDE drive, AMIBIOS does not configure that drive.
AMIBIOS does not wait for .5 seconds after sending
a RESET signal to the IDE drive to allow the IDE
drive time to get ready again. In Enabled, the
keyboard will be bypassed.
Note: You cannot run AMIBIOS Setup at system boot, because there is
no delay allowing you to hit <Del> to begin the Setup routine
.
Pri Master ARMD Emulated as
Pri Slave ARMD Emulated as
Sec Master ARMD Emulated as
Sec Slave ARMD Emulated as
Options for Pri Master ARMD Emulated as, Pri Slave ARMD Emulated as,
Sec Master ARMD Emulated as and Sec Slave ARMD Emulated as are
Auto, Floppy or Hard disk .
1st Boot Device
2nd Boot Device
3rd Boot Device
The options for the 1st Boot Device are Disabled, 1st IDE-HDD, 2nd IDE-