Supero SUPER S2DG2, User'S And Bios Manual

Page: 42 / 96

SUPER S2DG2/S2DGU/S2DGE/S2DGR
Manual
2-10
Top View of DIMM Socket
Figure 2-3. DIMM Installation
To Install:
Insert
vertically and
press down
until it snaps
into place.
Pay attention
to the two
notches.
To Remove:
Use your thumb to
gently push the
edge of the socket
and release the
module. Do this on
both sides for each
module.
Note: Notches
should align
with their
receptive points
on the socket
D I M M S o c k e t
Side View of DIMM Installation into Socket
DIMM
P C 1 0 0
Notches
P C 1 0 0
Notches
2-8 Connecting the Parallel Port, Floppy and Hard Disk
Drives
Use the following information to connect the floppy and hard disk drive cables.
• The floppy disk drive cable has seven twisted wires.
• A red mark on a wire typically designates the location of pin 1.
• A single floppy disk drive ribbon cable has 34 wires and two connectors to
provide for two floppy disk drives. The connector with the twisted wires always
connects to drive A, and the connector without the twisted wires always
connects to drive B.
• An IDE hard disk drive requires a data ribbon cable with 40 wires, and a SCSI
hard disk drive requires a SCSI ribbon cable with 50 wires. A wide SCSI hard
disk drive requires a SCSI ribbon cable with 68 wires.
• A single IDE hard disk drive cable has two connectors to provide for two drives.
To designate an IDE disk drive as C, you would normally set the drive select
jumper on the drive to DS1 (or Master). To designate an IDE disk drive as D,
you would normally set the drive select jumper on the drive to DS2 (or Slave).
Consult the documentation that came with your disk drive for details on actual
jumper locations and settings.
• A single SCSI ribbon cable typically has three connectors to provide for two