Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
287
[{volatile | nonvolatile}]
UserName -
Alphanumeric value with a
maximum of 40 characters.
Use authto enable authentication for
the user.
Passwd–
Password used for user
Authentication. Alphanumeric value
with a maximum of 40 characters.
Use privtoenableencryption of packets.
Passwd–
Password used to generate
keys for encryption of messages.
Alphanumeric value with a maximum of
40 characters.
Use volatileif the value need not be
stored in NVRAM.
Use nonvolatile if the value must be
stored in NVRAM and available after
restart.
Step 3 end
Exits the configuration mode.
Step 4 show snmp user
Displays the SNMP user information.
Step 5 write startup-config
Optional step – saves this SNMP
configuration to be part of the startup
configuration.
The “no snmp user <UserName> ”command deletes the specified user.
The example below shows the commands used to configure the SNMP user.
SMIS# configure terminal
SMIS(config)# snmp user user5 auth md5 abc123 priv DES xyz123
SMIS# end
SMIS# show snmp user
Engine ID: 80.00.08.1c.04.46.53
User: user5
