Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
121
Figure LA-2: Dynamic Link Aggregation
The figure above shows an example of a port channel configuration with port status and aggregated ports.
In this example, port 5 is not configured on LACP mode on switch B, and is therefore shown as being in the
“independent” state and not part of the aggregated ports.
4.6
Link Aggregation Port Channel
4.6.1
Creating Port Channels
Port channel creation involves two steps: the first is to create the port channel interfaces and the
second is to add member ports to the port channel interfaces.
4.6.1.1
Creating Port Channel Interfaces
Follow the steps below to create port channel interfaces in Supermicro switches.
Step
Command
Description
Step 1 configure terminal
Enters the configuration mode
Step 2 interface port-channel <
channel-group-number
>
Creates a port channel using “interface
Or
port—channel” command.
no interface range port-channel <
channel-group-
number
>
….
channel-group-number
– may be any
number from 1 to 65535.
