7.12 RS-485 Communication
Enter setup of RS-485 communication. According to the Modbus protocol, set the Transmitting
Mode, Baud Rate, Parity, Stop Bit, and ID number. About the detail of Modbus protocol, please
refer to Ch9 Modbus Protocol. If under HOLD status, the measurement signal output maintains
the last output value before HOLD status.
Press to confirm it.
Press to confirm it.
Press to confirm it.
Press to confirm it.
Press to confirm it.
Press to confirm it.
Press to confirm it.
Press to confirm it.
Press to confirm it.
Press to confirm it.
Enter
Ⱦ
Clock
ȿ
Setup
Press to confirm it.
Press to confirm it.
Press or to select
2400, 4800, 9600, or
19200 for Baud Rate.
t
t
t
to
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
9600
4800
Press or to select
RTU or ASCII mode
Press or to select
Even, Odd, or None for
Parity
t
N
Odd
Press or to
select 1 Bit or 2 Bit for
Stop Bit.
Press or to set
the ID number of the
transmitter. The valid
value is from 001 to 247.
s
нс
Summary of Contents for EC-4110-I
