32
5-10
IMMEDIATE STOP
Operation
5.4.4 Shutting down
Always shut down properly when work is complete:
•
Remove the and hub nut and the wheel from the
balancer.
•
Remove the cones from the stub shaft. Check the
surfaces (internal and external) of the cones for
damage. The condition of the cone is very important
for a good balance quality.
•
Store the cones and the hub nut in the correct place.
•
Check the thread of the hub nut and stub shaft.
•
Clean all threads and surfaces with a dry, soft cloth.
•
Unplug the mains cable from the power outlet.
•
Check the power cable for damage or wear.
•
Tidy up the storage areas.
•
Clean the display and input panel with a soft, dry cloth.
•
Remove old wheel weights and other material from
under the balancer. The balancer must rest on its
three feet only.
5.4.5
Removal of the wheel
•
Carefully untighten the quick release hub nut or the
mounting studs.
•
Do not slide the rim on the threads, but lift the wheel
when removing it.
•
Check the thread for damage and clean if necessary.
5.4.6
Immediate stop
See
Figure 5-10
.
To perform an immediate stop:
•
Select the STOP key to apply the electronic brake.
•
Apply the foot brake to stop the wheel.
When the immediate stop was made, due to an
unexpected action of the unit, rethink the steps
that were made:
Did the operator make an error or mistake?
Correct the input and proceed working. No
special procedure is to be followed.
Did the unit do something unexpected?
•
Read the relevant chapters again.
•
Prepare the unit for a restart: Switch on the unit.
•
Carefully repeat the commands with the manual at hand.
•
Call service immediately if the unit malfunctions
again and:
CAUTION
: PREVENT ANY FURTHER USE OF
THE UNIT.