90
7-2
7-1
Trouble shooting
7.1
System messages
The wheel balancer can show messa
ges to the
operator. These may be error related (E-codes) or
warnings (H-codes). The codes will be described in
the following chapters.
Whenever a code appears:
•
make a note of it;
•
look up the code in the list. If the code is not
described, call service team;
•
perform the steps described.
In special cases, or if the need arises, some operating
modes or states can be changed by entering the
appropriate codes (C Codes)
.
7.1.1
C Codes
Selecting and changing a code.
Example for
code C0 (Fig. 7-1)
—
Press and hold down
together
the
“
STAR
” (7) and
“
FINE
” (8) keys for 5 seconds
.
The C codes selection condition appears (
Fig. 7-2
).
—
Press one of the “
+
” (4) or “
-
” (6) keys until the
readout shows the desired code number (e.g.: C
0).
—
Press the
ENTER
key (5) to acquire the selection.
The right number readout shows the current state, e.
g.
:
“
0
” which in this case means switched off.
If the desired state is already on the readout:
—
Press the
STOP
key (
10, Fig. 7-1
) once to return to
C codes selection
(Fig. 7-2)
, and a second time to
defi nitively exit and return to the operating mode.
If the desired state is not that shown by the readout,
but needs selecting, proceed as follows:
—
Press one of the “
+
” or “
-
” keys until the right
readout shows the desired condition (e.g.
:
“
0
”).
Now two options are possible:
Option 1
—
Press the
ENTER
key to acquire the selection.
—
Press the
STOP
key to return to the operating
mode.
The operating mode change is complete and is saved
until a new setting is entered. When the machine is
switched off the settings are not deleted, and at each
subsequent start up they appear as previously set up
until changed again.
4 5 6
7 8
10
