Sun Microsystems SPARC Series, Service Manual

Page: 72 / 192

4-6 SPARC Enterprise M3000 Server Service Manual • January 2009
4. Type the
cfgadm -x
command to confirm that the CHECK LED blinks.
The Ap_Id is shown in the output of
cfgadm
(for example, disk#0 ).
The CHECK LED (amber) of the HDD blinks.
5. Type the
cfgadm
command to verify that the component has been
disconnected.
The disconnected component is displayed as being unconfigured.
4.3.2 FRU Removal and Replacement
After the disconnection of a FRU from a domain, the same procedure as that for Hot
Replacement/Hot Addition applies. See
Section 4.4, “Hot Replacement/Hot
Addition” on page 4-7 .
4.3.3 Configuring a FRU in a Domain
This section explains the procedure for active replacement/installation by using
Solaris OS commands. For information on using the XSCF command, see
Section 4.4,
“Hot Replacement/Hot Addition” on page 4-7 .
1. Type the
cfgadm -c
command from the Solaris OS to integrate the component
into the Solaris OS.
2. Type the
cfgadm -x
command to confirm that the CHECK LED is off.
The Ap_Id is shown in the output of
cfgadm
(for example, disk#0).
The CHECK LED (amber) of the HDD is turned off.
# cfgadm -x led=fault, mode=blink
Ap_Id
# cfgadm -a
# cfgadm -c configure
Ap_Id
# cfgadm -x led=fault, mode=off
Ap_Id