Sun Microsystems 817-4054-15, Servise Manual

Page: 98 / 204

6-12 Sun Fire E2900 System Service Manual • May 2006
FIGURE 6-11
Removing or Attaching the Baseplate to the Tape Drive
8. Attach the baseplate to the new tape drive. Use the four countersunk screws
shipped with the drive (
FIGURE 6-11
).
9. Install the new drive. Insert it into the system until the metal latch on the left side
engages.
6.3.2 Installing a New Tape Drive
1. Take the system to Standby mode.
See Section 4.2, “Taking the System to Standby Mode” on page 4-2 .
2. Open the right front door of the system.
3. Attach a wrist strap. Place a grounded ESD mat close to the system.
See Section 2.8, “Antistatic Precautions” on page 2-6 .
4. Pull the tape drive filler panel forward to remove it.
5. Remove the two countersunk screws that secure the tape drive filler panel to the
baseplate (
FIGURE 6-12
). Remove the tape drive filler panel.
Baseplate